|
SKC OSHA/NIOSH/ASTM Air Sampling Guide for Graphite (synthetic) (total dust)
| Chemical Hazard |
CAS. No. |
| Graphite (synthetic) (total dust) |
7782-42-5 |
Sampling Methodology |
|
| OSHA CSI |
|
Sampling Paramenters
|
Agency Standards (ppm) |
Volume |
Rate |
Time |
| TWA 15 mg/m3 |
960 L |
2000 ml/min |
8 hrs |
| Analytical Method |
| GR — Gravimetric Analysis |
| SKC Sampling Equipment |
| Filter 225-8-01 |
| Filter Cassette and Cyclone Holder 225-1 |
| Filter Cassette 225-2LF |
| Air Sampling Pump AirChek XR5000 210-5001 |
| Footnotes |
| CSI-OSHA Chemical Sampling Information (OSHA Website) |
Chemical Hazards by First Letter
| A | B | C | D | E | F | G | H | I | J | K | L | M | N | O | P | Q | R | S | T | U | V | W | X | Y | Z |
This SKC Air Sampling Guide is a reference only to assist users in finding the method, sampling equipment, and sampling media for a specific compound. This publication is intended for general information only and should not be used as a substitute for reviewing applicable government regulations, equipment operating instructions, or legal standards. Users must consult the appropriate sampling method for the compound of interest before sampling. The sampling parameters shown here are suggestions based on the ranges or volume, flow, and time specified in the methods. It is the responsibility of the analyst performing the sampling and analysis steps to adjust the parameters so that the required detection limits can be obtained. The information contained in this document should not be construed as legal advice or opinion nor as a final authority on legal or regulatory procedures.
|