SKC Inc. The World Leader in Sampling Technologies
  Headlines: New! SKC Webinars/Podcast
 Facebook Page button    Youtube button

Deal of the Month. Special pricing Click Here
SKC celebrates Tedlar return
SKC Connect button
SKC Feature Video

SKC OSHA/NIOSH/ASTM Air Sampling Guide for Halothane

Chemical Hazard CAS. No.
Halothane 151-67-7

Sampling Methodology


Chemical Fact File
OSHA 103 1347
Sampling Paramenters
Agency Standards (ppm)
Volume
Rate
Time
TWA  
12  L
50  ml/min
4  hrs
Analytical Method
GC-FID — Gas Chromatography-Flame Ionization Detector
SKC Sampling Equipment
Sorbent Tube   226-81A  
Air Sampling Pump Pocket Pump 210 Series Low Flow Pump 210-1002MH
Limit of Detection
87.3 pg
Note: The policies of the AIHA laboratory accreditation committee require that method detection limits must be established and statistically verified for each method by the laboratory. Whenever there is a change in methodology or instrumentation, detection limits must be reestablished. Detection limits posted here are for reference only. (See the AIHA quality manual, published July 1997.)
printer friendly page

Chemical Hazards by First Letter

A | B | C | D | E | F | G | H | I | J | K | L | M | N | O | P | Q | R | S | T | U | V | W | X | Y | Z

 

Chemical Hazard Search:  
  Enter chemical name in box above
CAS No. Search:  
  Enter CAS number in box above
Method Number Search:  
  Enter method number in box above

Catalog Number Search:  
  Enter the exact SKC catalog number in the box

This SKC Air Sampling Guide is a reference only to assist users in finding the method, sampling equipment, and sampling media for a specific compound. This publication is intended for general information only and should not be used as a substitute for reviewing applicable government regulations, equipment operating instructions, or legal standards. Users must consult the appropriate sampling method for the compound of interest before sampling. The sampling parameters shown here are suggestions based on the ranges or volume, flow, and time specified in the methods. It is the responsibility of the analyst performing the sampling and analysis steps to adjust the parameters so that the required detection limits can be obtained. The information contained in this document should not be construed as legal advice or opinion nor as a final authority on legal or regulatory procedures.
  About SKC Terms of Use Privacy Policy Contact Us Site Map Ordering Information
This site was last modified May 23, 2013
SKC Inc.'s Quality Policy is in Compliance with IS0 9001-2008
© Copyright 1995-2013 SKC Inc.