 |
|||||
| New! SKC Webinars/Podcast | |||||
SKC OSHA/NIOSH/ASTM Air Sampling Guide for Phoma species (fungi, molds, spores)
| Chemical Hazard | |
| Phoma species (fungi, molds, spores) | |
Sampling Methodology |
|
Agency Standards (ppm) |
Volume |
Rate |
Time |
| TWA | 120 L |
1000 ml/min |
2 hrs |
| Analytical Method |
| Varies — Analytical Method is dependant upon the nature of the sample. Refer to the method for details |
| SKC Sampling Equipment |
| Preloaded Filter Cassette 225-3-01 |
| Filter Cassette and Cyclone Holder 225-1 |
| Air Sampling Pump AirChek XR5000 210-5001 |
| Footnotes |
| Sample open face |
 |
printer friendly page |
Chemical Hazards by First Letter
| A | B | C | D | E | F | G | H | I | J | K | L | M | N | O | P | Q | R | S | T | U | V | W | X | Y | Z |
This SKC Air Sampling Guide is a reference only to assist users in finding the method, sampling equipment, and sampling media for a specific compound. This publication is intended for general information only and should not be used as a substitute for reviewing applicable government regulations, equipment operating instructions, or legal standards. Users must consult the appropriate sampling method for the compound of interest before sampling. The sampling parameters shown here are suggestions based on the ranges or volume, flow, and time specified in the methods. It is the responsibility of the analyst performing the sampling and analysis steps to adjust the parameters so that the required detection limits can be obtained. The information contained in this document should not be construed as legal advice or opinion nor as a final authority on legal or regulatory procedures.
| About SKC | Terms of Use | Privacy Policy | Contact Us | Site Map | Ordering Information |
SKC Inc.'s Quality Policy is in Compliance with IS0 9001-2008
© Copyright 1995-2013 SKC Inc.