SKC Inc. The World Leader in Sampling Technologies
  Headlines: SKC Webinars/Podcast
 Facebook Page button    Youtube button

Deal of the Month.  Special pricing Click Here
SKC celebrates Tedlar return
SKC Connect button
SKC Feature Video

SKC Passive Sampling Guide for 1-Chloro-2-methylbenzene (monochlorotoluene; OXSOL 10)

Chemical Hazard CAS No.
1-Chloro-2-methylbenzene (monochlorotoluene; OXSOL 10) 95-49-8
Agency Standards
OSHA TWA (ppm)   ACGIH TLV (ppm)
50   50
Sampling Parameters
Sampling Rate (ml/min) Minimum Sampling Time (min) Maximum Sampling Time (hrs)
13 15 8
Analytical Method
GC-FID — Gas Chromatography-Flame Ionization Detector
Desorption Efficiency % Desorption Solvent
91.8 Carbon disulfide (2 ml)
SKC Equipment
575-001 Passive Sampler for Organic Vapor, Charcoal sorbent  
Validation Type
Bilevel
A key member of an homologous series has passed Full and all other members have passed Partial. The validity of this has been shown by Guild et. al. (formerly referred to as Level 5B).

Guild, L.V., Myrmel, K.H., Myers, G. and Dietrich, D.F., 'Bi-Level Passive Monitor Validation: A Reliable Way of Assuring Sampling Accuracy for a Larger Number of Related Chemical Hazards' Appl. Occup. Environ. Hyg., Vol 7, No. 5, May 1992, pp. 310-317.
Footnotes
- NIOSH REL
OXSOL is a registered trademark of Occidental Chemical Corp.

Chemical Hazard Search:
  Enter chemical name in box above

Catalog Number Search:
  Enter the catalog number in box above

CAS Number Search:
  Enter the CAS number in box above

Chemical Hazards by First Letter

A | B | C | D | E | F | G | H | I | J | K | L | M | N | O | P | Q | R | S | T | U | V | W | X | Y | Z

This SKC Air Sampling Guide is a reference only to assist users in finding the method, sampling equipment, and sampling media for a specific compound. This publication is intended for general information only and should not be used as a substitute for reviewing applicable government regulations, equipment operating instructions, or legal standards. Users must consult the appropriate sampling method for the compound of interest before sampling. The sampling parameters shown here are suggestions based on the ranges or volume, flow, and time specified in the methods. It is the responsibility of the analyst performing the sampling and analysis steps to adjust the parameters so that the required detection limits can be obtained. The information contained in this document should not be construed as legal advice or opinion nor as a final authority on legal or regulatory procedures. CAS Registry Number is a Registered Trademark of the American Chemical Society.

 

  About SKC Terms of Use Privacy Policy Contact Us Site Map Ordering Information
This site was last modified September 16, 2014
SKC Inc.'s Quality Policy is in Compliance with IS0 9001-2008
© Copyright 1995-2014 SKC Inc.