|
SKC
Passive Sampling Guide for Hexylene glycol
| Chemical Hazard |
CAS No. |
| Hexylene glycol |
107-41-5 |
| Agency Standards |
| |
OSHA C/STEL(ppm) |
ACGIH TLV (ppm) |
| |
25# |
25 (C) |
| Sampling Parameters |
| Sampling Rate (ml/min) |
|
|
| 11.5 |
|
|
| Analytical Method |
| GC-FID — Gas Chromatography-Flame Ionization Detector |
| SKC Equipment |
| 575-002 Passive Sampler for Organic Vapor, Anasorb 747 sorbent |
| Validation Type |
Calculated
Uptake rate that is calculated from the physical properties of the analyte and geometry of the sampler. Calculated rates are not based upon direct laboratory testing of the analyte with the sampler. Calculated validations are not recommended for compliance sampling. |
| Footnotes |
# - NIOSH STEL level
|
Chemical Hazards by First Letter
| A | B | C | D | E | F | G | H | I | J | K | L | M | N | O | P | Q | R | S | T | U | V | W | X | Y | Z |
This SKC Air Sampling Guide is a reference only to assist users in finding the method, sampling equipment, and sampling media for a specific compound. This publication is intended for general information only and should not be used as a substitute for reviewing applicable government regulations, equipment operating instructions, or legal standards. Users must consult the appropriate sampling method for the compound of interest before sampling. The sampling parameters shown here are suggestions based on the ranges or volume, flow, and time specified in the methods. It is the responsibility of the analyst performing the sampling and analysis steps to adjust the parameters so that the required detection limits can be obtained. The information contained in this document should not be construed as legal advice or opinion nor as a final authority on legal or regulatory procedures.
|
