SKC: Shaping the Future of Air Sampling  
 
 Español
 Deutsch
 Français
 Portuguese
 

 

 

Grab Air Sample Pump

Simple, Reliable, Economical Bag Sampling

Grab Air Sample Pump 222-2301
  • Uses 9-V disposable battery — no down time for battery charging

  • Low-battery indicator

  • 1 L/min flow rate

  • Approximately 1000 liters volume on one battery

  • Minimum setup time — simply attach a bag and sample

     

Grab Air Sample Pump 222-2301

Grab Air Sample Pump Spec. Sheet (PDF)

Grab Air Sample Pump Operating Instructions (PDF)

The Grab Air Sampler is a hand-held battery-operated sample pump designed to fill bags at 1 L/min efficiently and reliably. A simple "turn on and sample" pump, Grab Air operates on a disposable 9-volt battery. An LED indicates low battery. The Grab Air Sample Pump is recommended for sample bags up to 10 liters.
Bag Sampling Train With Grab Air Sample Pump

Principle of Operation

The Grab Air Sampler pulls air containing the sample into the pump at approximately 1 L/min and immediately exhausts it into a sample bag connected to the pump with Teflon tubing. Sampling is complete when the bag is properly filled (see Bag Sampling).

Bag Sampling

Sampling Tips

  • Use only Teflon tubing and a Teflon-lined septum for bag sampling to prevent sample loss.

  • Flush bags thoroughly with purified air or nitrogen before use.

  • Do not use bags to collect unstable or highly reactive compounds.

  • Do not ship sample bags by air unless the cargo cabin is pressurized.

  • When sampling for light-sensitive compounds, use black layered Tedlar bags.

  • When sampling for CO or CO2, use SKC Foil Grab Bags (245 Series).

  • Long-term storage of compounds in Tedlar bags is not recommended as chemicals can adsorb onto the inside surface of the bag.

  • The O-ring in the sampling valve on SKC sample bags withstands temperatures up to 200 F (93.3 C). Use this as a sampling guideline.

  • Avoid filling any bag more than 80% of its maximum volume. Visually inspect the bag as it is filling to determine when sampling is complete.

Performance Profile

Flow rate: Approx. 1 L/min

Operation time: Approx. 1000 liters volume per battery dependent on battery quality

Battery: Disposable 9-volt alkaline

Pumping action: Diaphragm

Case: Sturdy, lightweight plastic

Intrinsic safety: Not intended for use in explosive or hazardous locations


Protect sample pump from weather when in use outdoors.

Ordering Information           Online Ordering

Description
Cat. No.
Grab Air Sampler with 9-volt battery Grab Air Sampler with 9-volt battery  Cat. No. 222-2301
Grab Air HazMat Kit includes Grab Air pump with 9-V battery and ten 1-liter bags with single polypropylene fitting Grab Air Pump Kit for Haz-Mat  cat. no. 222-2111
SKC Universal Screwdriver Kit for use with sample pumps. Includes 3 interchangeable screwdriver heads. 224-11

Grab Air Sample Pump Spec. Sheet (PDF)

Grab Air Sample Pump Operating Instructions (PDF)


SKC Air Sampling Pumps Page

Pump Accessories (Chargers, Calibrators, Flowmeters) Page

This page was last modified April 24, 2009
  About SKC Terms of Use Privacy Policy Contact Us Ordering Information

This site was last modified July 2, 2009

SKC Inc.'s Quality Policy is in Compliance with IS0 9001-2000
© Copyright 1995-2009 SKC Inc