• 10 to 30 L/min constant flow sample pump
  • Maintains set flow throughout a sampling period for complete sample integrity
  • Ideal for use with BioStage viable cascade impactors, spore trap cassettes such as the VersaTrap, microvacuum cassettes, or other samplers that require flows up to 30 L/min within the back pressure range of the pump
  
  
• Long run times on one Li-Ion battery charge
  • AC charger/adapter for extended sampling
  • Rechargeable lithium-ion battery pack
  
  
• Easy-to-use programmable timer for unattended sampling
  • Select sample time presets or customize timer from 1 to 999 minutes
  • Continuous run with manual shut-off
  • Intermittent sampling
  
  
• Compact and portable
  • 9.3 x 8.4 x 3.5 inches (23.6 x 21.3 x 8.9 cm)
  • Weighs only 4.8 pounds (2.2 kg)
  • Portable with easy-grip handle
  
  
• Optional mounting bracket for viable impactor
  
  
• One handed transport of pump and BioStage Impactor
  
  
• Easy to use
  • Large keypad control
  • End-of-cycle visible and audible alarms
  • Handy front-mounted intake for fast and simple media setup
  • Fast setup
  
  
• High-contrast digital display
  
  
• Low noise
  • Average < 64 dBA at 3 feet (37-mm, 0.8-µm MCE filter at 16.8 L/min)

‡	Pump sampling at 10 L/min using 37-mm 0.8-µm MCE filter with new pumps and batteries. Pump performance may vary. See additional run times in Performance Profile.

 

 

 

Performance Profile

Flow Range	10 to 30 L/min
Flow Compensation Accuracy	± 5% of set flow
Compensating Flow Back Pressure Range	10 L/min at 90 inches water back pressure 20 L/min at 50 inches water back pressure 30 L/min at 15 inches water back pressure
Typical Back Pressure of Sampling Media (inches water) Flow Rate L/min 10 12 15 20 Filter/Pore Size (µm)   25-mm MCE/0.8 65 80 103 148 25-mm MCE/0.45 138 172 > 200 — 37-mm MCE/0.8 22 28 36 51 37-mm PVC/5.0 9 11 15 21 Compare the information in this table to compensation range to determine appropriate applications.
Power	Rechargeable lithium-ion (Li-Ion) battery, 7.4-volt, 10.4-Ah capacity, 77 Wh, or battery with AC charger/adapter (100-240 V)
Battery Recharge Time (varies with battery capacity and level of discharge)	Approximately 5 hrs with approved charger
Typical Cumulative Run Time‡	Spore Trap cassettes (VersaTrap): 5 hrs at 15 L/min (battery only) BioStage viable cascade impactor: 4 hrs at 28.3 L/min (battery only) 25-mm, 1.2-µm MCE filter: 9+ hrs at 10 L/min To achieve, use QuickTake 30 with a fully charged battery and AC charger/adapter. 37-mm, 0.8-µm MCE filter: 14+ hrs at 10 L/min (battery only) Note: The AC charger/adapter can be used to extend battery run time, but it is not a battery eliminator. Therefore, it will not provide indefinite run times.
Temperature	Operating: 32 to 104 F (0 to 40 C) Storage: -4 to 95 F (-20 to 35 C) Charging: 32 to 113 F (0 to 45 C)
Operating Humidity	0 to 95% non-condensing
Run Time Features	User-selectable features, user-adjustable presets. See Operating Instructions. Preset timed runs: 1, 2, 5, 10, or 15 min Manually set continuous run with manual shut-off: 1 to 999 min (repeats 1 to 999-min runs indefinitely until user stops pump or power supply is depleted) Intermittent sampling: User-set sample periods and sample delays. See Operating Instructions.
Flow Fault Features	If the pump is unable to compensate due to excessive back pressure, the pump will go into flow fault mode. Flow fault features are enabled as the default setting. Flow fault may be disabled at the user’s option. See Operating Instructions. Flow fault: Flow fault displays immediately. Pump shuts off after 5 seconds. Fault restart: Pump attempts restart every 10 seconds up to five times.
Media Compatibility	BioStage viable cascade impactor, VersaTrap spore trap cassettes, microvacuum cassettes, and other samplers that require flows to 30 L/min
Tubing	Requires 3/8-inch ID tubing
Housing	ABS plastic
Dimensions	8.4 x 9.3 x 3.5 in (21.3 x 23.6 x 8.9 cm)
Weight	4.8 lbs (2.2 kg)
Noise Level	Average < 64 dBA at 3 feet (37-mm, 0.8-µm MCE filter at 16.8 L/min)

‡	Results are obtained using a new pump and new fully charged battery. Pump and battery performance may vary.

Do not operate or charge in hazardous locations. Not UL Listed for intrinsic safety.
Protect sample pump from weather when in use outdoors.

 

 

 

 

 

 

QuickTake 30 High Flow Pump
Constant Flows for Dust, Mold, Bioaerosol, Asbestos, and More

The SKC QuickTake 30 constant flow diaphragm pump maintains a set flow rate throughout the sampling period, compensating for the inherent back pressure created by sampling media and for any increase in back pressure as sample collects on the media. Unlike similar pumps, the QuickTake 30:

• Maintains true constant flow


• Does not require a special rotameter or hot-wire anemometer for calibration

Ideal for use with the BioStage
 
QuickTake 30 with BioStage on mounting bracket

It's high flow sampling on the go! The portable SKC QuickTake 30 Sample Pump provides fast, easy sampling with the SKC BioStage Viable Cascade Impactor and one handed transport of pump and sampler. Use the simple mounting bracket accessory to attach the BioStage directly to the QuickTake 30 pump. There is no need for bulky accessories or line voltage. Sampling with an impactor couldn't be easier!

*

Li-Ion Battery Shipment Rechargeable lithium-ion batteries for use with SKC sample pumps have been tested in accordance with the UN Manual and are proven to meet requirements of each test in the UN Manual of Tests and Criteria, Part III, subsection 38.3. The batteries are rated below 100 watt-hours (Wh). Consult with your carrier for information on Lithium Battery Shipping Regulations for UN 3480 and/or UN 3481 or see SKC Sample Pump Lithium-Ion Battery Packing and Shipping Requirements for more information

 

 

 

 

 

QuickTake 30 Operating Instructions (PDF)

QuickTake 30 Operating Instructions Chinese (PDF)

QuickTake 30 Operating Instructions Portuguese (PDF)

QuickTake 30 Spec. Sheet (PDF)

QuickTake 30 Secondary Li-ion Battery Pack UL Certificate (PDF)

Technical Note: SKC Sample Pump Lithium-Ion Battery Pack Characteristics and Maintenance (PDF)

Technical Note: SKC Sample Pump Lithium-Ion Battery Packing and Shipping Requirements (PDF)

SDS for Lithium-Ion Rechargeable Battery (PDF)