SKC OSHA/NIOSH/ASTM Sampling Guide for Yttrium (Elements by Cellulosic Internal Capsule Sampler)

Chemical Hazard

Yttrium (Elements by Cellulosic Internal Capsule Sampler)

CAS. No.

7440-65-5

Sampling Methodology

NIOSH 7306


Sampling Parameters

Agency Standards (ppm)

Volume

Rate

Time

TWA 1 mg/m3

1-2000 L

1000-4000 ml/min

varies hrs

Analytical Method

ICP-AES


SKC Sampling Equipment

Solu-CAP MCE Filters Preloaded in Cassettes:225-8517 

Filter Cassette and Cyclone Holder:225-1 

Air Sampling Pump:220-5000TC 

Limit of Detection

Varies see method for list


This SKC Air Sampling guide is a reference only to assist users in finding the method, sampling equipment, and sampling media for a specific compound. This publication is intended for general information only and should not be used as a substitute for reviewing applicable government regulations, equipment operating instructions, or legal standards. Users must consult the appropriate sampling method for the compound of interest before sampling. The sampling parameters shown here are suggestions based on the ranges or volume, flow, and time specified in the methods. It is the responsibility of the analyst performing the sampling and analysis steps to adjust the parameters so that the required detection limits can be obtained. The information contained in this document should not be construed as legal advice or opinion nor as a final authority on legal or regulatory procedures.

View All Sampling Guides

a b c d e f g h i j k l m n o p q r s t u v w x y z