SKC Passive Sampling Guide for Mercury

Chemical Hazard

Mercury

CAS. No.

7439-97-6

Agency Standards OSHA TWA (ppm)

0.1 mg/m3 C

ACGIH TLV (ppm)

0.01 ug/m3


Sampling Parameters

Sampling Rate (ml/min)

Minimum Sampling Time (min)

Maximum Sampling Time (hrs)

20

8

Analytical Method

AAS

Desorption Efficiency %

Desorption Solvent


SKC Sampling Equipment

Capsule:520-02A and

Capsule Holder:520-03 

Validation Type

OSHA ID 140

Footnotes

Analysis: Consult OSHA Method ID 140 and MDHS 16 for detailed analytical procedures.

This SKC Air Sampling guide is a reference only to assist users in finding the method, sampling equipment, and sampling media for a specific compound. This publication is intended for general information only and should not be used as a substitute for reviewing applicable government regulations, equipment operating instructions, or legal standards. Users must consult the appropriate sampling method for the compound of interest before sampling. The sampling parameters shown here are suggestions based on the ranges or volume, flow, and time specified in the methods. It is the responsibility of the analyst performing the sampling and analysis steps to adjust the parameters so that the required detection limits can be obtained. The information contained in this document should not be construed as legal advice or opinion nor as a final authority on legal or regulatory procedures.

View All Sampling Guides

a b c d e f g h i j k l m n o p q r s t u v w x y z